What bad operations will reduce the service life of the feed harvester?

As is well known, reasonable use of green feed harvesters can not only improve work efficiency, but also reduce labor and provide many conveniences. However, what operations can reduce service life?

1. During the running-in period, the load capacity of the green feed harvester shall not exceed 80% of the rated mass. When starting to use, you first need to drive an empty vehicle for a certain distance, and then gradually increase the load. All stops driving under various loads must gradually rise from low to high, and each stop needs to be worn in.

2. The accelerator often slows down, and it is necessary to slow down when working in the field or passing through drainage ditches in the field. If the method of reducing throttle speed is adopted based on previous experience, it will affect the quality of operation, and on-site operations cannot be started immediately after starting. Some farmers may start field operations immediately after starting the green feed harvester. The manufacturer stated that this actually poses a great threat to the equipment.

Green feed harvester

If you want to improve the lifespan of the green feed harvester, the following methods are still very effective:

1. After the harvest season ends, loosen the conveyor belts and springs in each part. The conveyor belts should be unloaded and stored in the warehouse. Clean the dust and oil stains in each part, paint the paint off parts, and remove the conveyor chains in each part. After cleaning, soak them in engine oil and store them in the warehouse.

2. When operating the green feed harvester normally, the operating height of the corn straw should be adjusted correctly. To avoid damaging the cutting blade, stubble height should also be left. At the same time, before harvesting, the gearbox should be checked for oil shortage and the chain should be lubricated regularly.